I'm missing a certain group of channels with my DTT receiver

Support Center » Knowledgebase » General Troubleshooting » I'm missing a certain group of channels with my DTT receiver

	I'm missing a certain group of channels with my DTT receiver

Solution After Auto Tuning, some channels can be missing if the DTT signal is too low, or too high. When that happens, some channels (perhaps just one multiplex) can be cut off. That means a related group of channels may be missing. Often, this happens with ITV in the UK.

Units like the TVMini or EyeTV for DTT may exhibit this problem, especially for customers with a very high signal strength (approaching 100%)

A few customers with this circumstance have found that signal attenuators have helped.

Those are very inexpensive ways to slightly reduce the signal, which can help receive channels like ITV.

See these examples: http://www.dastv.co.uk/DAS/Products/ProductSearch.aspx?category=0&RangeName=Search&rangeid=0&freetext=attenuator&x=0&y=0

We recommend that you try with a variable attenuator 0-20dB.

Article Details

Article ID:

1030

Created On:

21 May 2008 11:32 PM

This answer was helpful

This answer was not helpful

Back

Search

Article Options

Home | Contact Tech Support | Knowledgebase | Downloads

| | Deutsch | Français |

Help Desk Software By Kayako eSupport v3.40.01