I have many missing channels when scanning a satellite, adding them manually doesn't work

Support Center » Knowledgebase » EyeTV Video Sources » Satellite » I have many missing channels when scanning a satellite, adding them manually doesn't work

	I have many missing channels when scanning a satellite, adding them manually doesn't work

Solution If you use two or more satellites, check that the order of the satellite in EyeTV's satellite setup is the same as the order of the LNBs connected to the switch (each LNB points to a particular satellite).

Note: always use "DiSEqC 1.0" for "Equipment control" parameter.

Article Details

Article ID:

3091

Created On:

09 Sep 2008 09:20 AM

This answer was helpful

This answer was not helpful

Back

Search

Article Options

Home | Contact Tech Support | Knowledgebase | Downloads

| | Deutsch | Français |

Help Desk Software By Kayako eSupport v3.40.01